Axel Oxygen 5 Especificaciones descargar pdf (Pagina 12)

Oxygen 5

Pag. 12

3.1 INTRODUCTION

The Mono module features two mono inputs (Input A and Input B). Input A is factory pre-set on microphone

level but it can be also easily set on line level. Input B is set only on line level.

3.2 A INPUT

Input A is electronically balanced on female XLR.

Through jumper setting you can change the input A gain to fit the Micro level or the Line

level; a fine gain adjustment only of the Micro level can be achieved through the trimmer

‘Gain input A’ (see GAIN INPUT A Trimmer). Operate on it if the Gain control doesn’t

amplify or attenuate enough the source signal.

Input A is set ex-work on -54dB level (average level of Micro signal).

The plug pin-out presents standard configuration:

• Sleeve  Ground

• Tip  Signal

• Ring  Return

We suggest to use Input A for Micro signals and B for Line signals and to use everywhere

balanced links. See Appendix A for wire connection schemes

3.3 PHANTOM POWERING

48 Volts are provided for phantom powering of condenser microphones. A module internal

jumper (see module internal layout at the end of the chapter) allows to disconnect the 48

volts whenever microphones don’t require external powering.

Attention: always disconnect phantom powering if not necessary and do not use

asymmetrical sources on the microphones input with the phantom power ON.

3.4 B INPUT

Input B (fixed Line level) is electronically balanced on female Jack with 0 dB gain.

The plug pin-out presents standard configuration:

• Sleeve  Ground

• Tip  Signal

• Ring  Return

We suggest to use everywhere balanced links. See Appendix A for wire connection

schemes

3.5 INSERT INPUT A

The INSERT connector allows to insert external equipment (like sound / effect processors,

compressors, filters, etc) between the input A buffer and the remaining stages of module

audio chain.

INSERT point carries an output level of 0 dB (on 100Ω impedance) and an input level of 0

dB (on 10KΩ impedance).

The plug pin-out presents the following configuration:

• Sleeve  Ground (audio common)

• Tip  Signal Output

• Ring  Signal Input (audio return)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Oxygen 5 1

Comentarios a estos manuales

Sin comentarios

Axel Oxygen 5 Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Mezcladores de audio Axel Oxygen 5