Axel AX3000 65 User's Manual Manual de usuario descargar pdf (Pagina 203)

Remote Set-Up

AX3000 - User's Manual 191

When the set-up parameters have been loaded, the message '

OK, set-up

sent

' is displayed on the operator’s console. If other messages are displayed,

refer to chapter 10.2.3.

The configuration file lists each set-up parameter. Refer to Appendix A.5 for a

detailed description of this file.

10.2.3 - Error Messages

There are two types of error:

- fatal errors: numbered from 100 to 114,

- warning errors: numbered from 200 to 221.

a) Fatal Errors

Fatal errors stop the remote command. The following fatal errors may occur:

ERR 101: header label expected.

Command: setup_send

Cause: the AXEL header label (BEGIN_AX_SETUP) is not the first

line of the configuration file.

Consequence: the AX3000 set-up is not modified.

Solution: check the file. Replace it with a correct configuration file.

ERR 102: bad header label protocol version.

Command: setup_send

Cause: the protocol version (included in the header label) cannot be

processed by the current AX3000 firmware.

Consequence: the AX3000 set-up is not modified.

Solution: use a configuration file with a compatible protocol.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 275 276

Sin comentarios

Axel AX3000 65 User's Manual Manual de usuario Pagina 203