Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guía de usuario descargar pdf (Pagina 13)

Setting the Configuration

________________________________________________________________

8 TCP/IP AXEL Platine Terminal

This chapter provides the general information needed to install and configure

TCP/IP AX3000 Platine terminals on an Ethernet network.

The main steps to install a Platine terminal are:

- assign an Internet address matching the network topology,

- define the network environment accessible from this Platine terminal

(Telnet hosts, routers, etc),

- associate a host with each Platine terminal session,

- set terminal parameters (emulation, function keys, etc) for each available

Platine terminal session.

The first three steps use the terminal’s TCP/IP Set-Up, as described below. The

fourth step is invoked from Terminal Set-Up.

Note: the following pages describe the installation and use of TCP/IP

Platine terminals. This procedure assumes that a UNIX TCP/IP package

has been correctly installed.

2.1 - TCP/IP SET-UP

The following command sequence is used to enter TCP/IP Set-Up:

Note: use the <

> key on the numeric keypad.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 119 120

Sin comentarios

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guía de usuario Pagina 13