Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manual de usuario descargar pdf (Pagina 165)

Remote Set-Up

TCP/IP AX3000 User's Manual 155

10.2 - AX3000 REMOTE SET-UP

To set-up an AX3000 remotely, use the 'setup_send' command. Example for

Unix/Linux:

# rsh axname setup_send password < conf_file

Notes:

- The next chapter explains how to create the configuration file conf_file,

either using a text editor or using the 'setup_get' command on an

existing terminal. Appendix A.6 contains a detailed description of the

configuration file.

- password: specify the password if the set-up is password-protected.

The message 'Store set-up in progress...' is displayed on the

operator’s console while the remote command is processing. If a connection

problem occurs, a time-out error message is displayed.

When the configuration has been successfully completed, the message 'OK,

set-up updated' is displayed on the operator’s console. If other messages

are displayed, refer to Chapter 10.4.

The AX3000 must read this new set-up before it will take effect. This can be

achieved either by power-cycling the AX3000 or by the following 'ax_reboot'

command. Example for Unix/Linux:

# rsh axname ax_reboot password

Note about password: specify the password if the set-up is password-

protected.

The message 'Reboot in progress...' is then displayed on the operator’s

console, the AX3000 is reset and the new set-up is implemented. If a

connection problem occurs, a time-out error message is displayed.

10.3 - OBTAINING A CONFIGURATION

To obtain the configuration from an existing AX3000 terminal, use the

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 239 240

Sin comentarios

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manual de usuario Pagina 165